Fusion Studio Works
Oberon 2A - Angled Studio Desk for Mastering
Features
Aimed squarely at the mastering engineer, Oberon 2A boasts two bays of eight rack units which are angled towards the central listening position. The 'wrap-around' geometry allows you to access the masses of 19" outboard gear you've collected over the years. Elevate your studio speakers on the angled platforms and finally get your mastering signal chain sorted.
Studio Ergonomics
The angled speakers and computer display shelf is set relatively low to the floor in order to minimize acoustic reflections and provide sufficient separation for your array of speakers to breath.
Cable Management
Is achieved by the provided large cable channel located at the rear of the central work area. Each end of the cable channel feeds into the left and right rack bays.
In the rear of the racks, the supplied lacing bars are mounted between the rack strips, to which you can tie cables.
Cabling through holes allow for cable routing between every nook of the desk.
Available in black, white and natural grain finishes.
Product Specifications
- Desk Footprint Dimensions: Width 2249 x Depth 946mm.
- Worktop Dimensions: Width 1585 x Depth 438mm.
Elevation/height: 734mm.
- Speaker platform (rack bay top panel)
Dimensions: Width 522 x Depth 382mm.
Elevation/height: 896mm.
- Angled left and right rack bays of 8RU
Angled 23.6 degrees inward from sitting position.
Angled 68 degrees from vertical.
- 16 rack units total.
- Central computer display shelf.
Elevation/height: 896mm.
- Central cable channel at the rear runs between both racks for easy cable management.
Cable channel internal dimensions: Width 1291 x Depth 141 x Height 190mm.
What's Included
- 8RU rack rails tapped for M6 bolts to font and rear of racks
- 4x lacing bars for cable management
- 40x M6 bolts for rack equipment and lacing bars
- A4 printed assembly manual
- Electronic PDF assembly manual
What's Not Included
- A/V and 19" outboard rack equipment, other electronics, signal connection plates, power and cabling
- Speaker stands and vented rack plates
Shipping & Collection Options
- Flat-packed in cartons for on-site user assembly
- Factory assembled and delivered as a completed unit
- Collect assembled or partially assembled from our workshop:
392 Victoria Street, Brunswick 3058, VIC




Product Dimensions
Section Drawings