Fusion Studio Works
Arcade 2A - Studio Desk for Mastering
Features
Arcade 2A is a compact studio desk for the mastering engineer. Featuring two bays of eight rack units, indulge your chronic case of 'gear acquisition syndrome' and put within easy reach all that 19" outboard gear you've collected over the years. Elevate your studio speakers on the upper shelf and finally set up your studio for a consistent workflow.
Studio Ergonomics
The speakers and computer display shelf is set relatively low to the floor in order to minimize acoustic reflections and provide sufficient separation for your array of speakers to breath.
Cable Management
In the rear of the racks, the supplied lacing bars are mounted between the rack strips, to which you can tie cables.
Cabling through holes allow for cable routing between every nook of the desk.
Available in black, white and natural grain finishes.
Product Specifications
- Desk footprint dimensions: Width 1029 x Depth 1051mm.
- Worktop dimensions: Width 1029 x Depth 300mm.
Elevation/height: 734mm.
- Computer display/speakers shelf.
Dimensions: Width 1029 x Depth 382mm.
Elevation/height: 896mm.
- 2 rack bays of 8RU above the desktop (68 degrees from vertical).
- 2 rack bays of 4RU below the desktop
- 24 rack units total.*
* The positioning of outboard gear in the upper rack in relation to the lower rack requires coordination because not all loading combinations are possible. Units may obstruct one another depending on their relative positions. The design intent is for the lower racks to be loaded with vented rack plates to promote air circulation. Please refer to the sectional diagram in the image gallery
What's Included
- 8RU rack rails tapped for M6 bolts to font and rear of racks
- 4x lacing bars for cable management
- 36x M6 bolts for rack equipment and lacing bars
- A4 printed assembly manual
- Electronic PDF assembly manual
What's Not Included
- A/V and 19" outboard rack equipment, other electronics, signal connection plates, power and cabling
- Speaker stands and vented rack plates
Shipping & Collection Options
- Flat-packed in cartons for on-site user assembly
- Factory assembled and delivered as a completed unit
- Collect assembled or partially assembled from our workshop:
392 Victoria Street, Brunswick 3058, VIC


Product Dimensions
Section Drawings